Swisslog's Forum › Swisslog version 5.x › General discussion v
Rotor control

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Rotor control
19-10-2021, 12:29 AM, (This post was last modified: 19-10-2021, 04:09 PM by EA3GCV.)
#8
EA3GCV Offline
Super Moderator
******
 		Posts: 1.690
Threads: 147
Joined: May 2013
Reputation: 12
RE: Rotor control
Hi Tom,

I have revised the code related to Prosistel and I didn't find anything strange. It handles COM port the same way as it's handled with other interfaces. Moreover, I have connected remotely with another user having a Prosistel D like you with N1MM and all is working flawlessly. I have started Swisslog several times and rotor is working. The same running N1MM, closing it and starting Swisslog. No issues at all and I have performed this operation many times. Review all and use 9600 bauds as serial port rate. I guess something is wrong in your rotor controller. But there is no issues caused by Swisslog at all.

Best 73
Jordi, EA3GCV
Current developer of Swisslog
Find
Reply


Messages In This Thread
Rotor control - by JW6VDA - 17-09-2021, 12:27 PM
RE: Rotor control - by EA3GCV - 17-09-2021, 12:37 PM
RE: Rotor control - by JW6VDA - 18-09-2021, 09:20 AM
RE: Rotor control - by JW6VDA - 18-09-2021, 02:24 PM
RE: Rotor control - by EA3GCV - 21-09-2021, 02:23 AM
RE: Rotor control - by JW6VDA - 21-09-2021, 08:05 AM
RE: Rotor control - by JW6VDA - 18-10-2021, 03:45 PM
RE: Rotor control - by EA3GCV - 19-10-2021, 12:29 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)