Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
insert new mode
11-09-2017, 11:33 PM,
#11
RE: insert new mode
Hi Arne,

Could you explain better what's your problem? I don't understand what you want to explain. Reinstall your MicroHam drivers if you don't have accesa to the MicroHam control panel to setup transceiver COM port.

Best 73
Jordi, EA3GCV
Current developer of Swisslog
Reply
12-09-2017, 07:29 PM,
#12
Photo  RE: insert new mode
Good evening
will try to

Set up in the moment

Swisslog 5.96
MicroHam 2R+ controlling to station controlled via Omnirig have the small window in top
First picture is before logging QSO from WSJT-X
remark frequency window

Second picture is after the small window have been there and I say OK
Frequency left  and it is not coming back before restart of Swisslog
Off some reason Im not able to insert picture but they are in the attachment
Br Arne


Attached Files
.docx   Jordi2.docx (Size: 69,44 KB / Downloads: 5)
Reply
13-09-2017, 01:36 AM,
#13
RE: insert new mode
Hi Arne,

Do you mean that after logging QSO in WSJT-X the frequency in the transceiver toolbar of Swisslog disappear as displayed in the second screenshot? Have you configured WSJT-X to use Omnirig and read ok thine frequency from the transceiver? You have to use Omnirig in WSJT-X this way you will share the transceiver control in both Swisslog and Omnirig without any problems. Send me screenshots of your transceiver setup in WSJT-X but it's not normal that after logging the QSO in WSJT-X the QRG readout in Swisslog disappear. Please make sure you are using OmniRig in both programs to avoid problems with CAT control.

If you still have problems we will have to arrange a remote session via Teamviewer to see online what's happening but it should work perfectly.

Best 73
Jordi, EA3GCV
Current developer of Swisslog
Reply
13-09-2017, 10:28 PM,
#14
RE: insert new mode
Hello Jordi
Yes Im using Omnirig for both program
Have TS870 and FT-857 so I shift direct radio in the small window in Swisslog
This work pretty good
Will tomorrow make screenshot to veryfy it

Br Arne OZ4VW
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)