Posts: 14
Threads: 1
Joined: May 2013
Reputation:
0
RE: NEW version 5.102
Hello Jordi,
Nice work, many thanks for supporting SWISSLOG.
I have an issue, when I try to define a second trasceiver, i select Icom and then Swisslog searches a Com1 port, which I do not have on my computer, and then Swisslog crashes. I have to modify manualy the INI file and delete the entry for the second transceiver.
Posts: 14
Threads: 1
Joined: May 2013
Reputation:
0
RE: NEW version 5.102
Hello Jordi,
The error commes again, but Swisslog does nocrash, so I can modify the COM port number.
Anyway, when I set my Icom IC-705 as Radio 1 it works, but if I put my FTdx-1010d as radio 1 and try to set the IC-705 as radio 2 there is no communication with the radio .
Posts: 1.689
Threads: 147
Joined: May 2013
Reputation:
12
RE: NEW version 5.102
Hello George,
The error message will always pops up if COM port doesn't exists. You should have communication, otherwise check the COM port settings and (important!) it should match with the radio menu settings. Avoid using AUTO for Baud setting in your radio. Always set a fixed speed such 9600 or 19200 in your radio then set the same in Swisslog. I use 2 different radios on my setup with no problems.
If you still have problems contact me via whatsapp to arrange a remote Teamviewer session but it should work well.
Posts: 14
Threads: 1
Joined: May 2013
Reputation:
0
RE: NEW version 5.102
Hello Jordi,
No, still not possible to have the Yaesu as Rig 1 and the Icom as Rig 2. Additionally Swisslog crashes when I try to set it that way. I have set now Icom as Rig 1 and Yaesu as Rig 2 and it works OK, but as the FTdx-101 is my primary Rig I would prefer to have it as Rig 1.
Anyway many thanks for your help and work. I will try more tests tomorrow.