Hi ,
In case you use SwissLog with PSTrotaor, I would like to ask about your configuration. I have tried several, but till now it is not working.
PSTrotator itself works well I have tested alone and also with other logbook, however in Swisslog I can not make it work till no:
It seems there is no communication between each other.
Your help would help a lot.
Many Thanks
73 - Manuel Fernando
Hi all
Very good news!
It is working, however I do not get any value in Azimuth window, always showing and pointing "0"
Clicking in Azimuth it sends the value to rotator and rotator turns, but there is no reading nor in Azimuth Window nor in Rotor-Interface window…
Any idea?
Have a nice weekend.
73 Manuel Fernando CT1BXX
Hi Manuel,
You have to configure Swisslog as Tracker in Pstrotator. Do not change port and IP. However you can do it but you have to set the same port and IP in Swisslog when selecting Pstrotator in the rotor configuration. Afterwards you have to select the Tracking mode in Pstrotator (not manual) and Will work perfectly.
Best 73
Hi,
A miracle happens today
Today I update my Antivirus Kaspersky version 19.0.0.1088(a). After that I turn one Swisslog and the miracle happens ! ! !
No change at all on Swisslog configuration , but now I get Azimuth Windows working properly the indication is working since rotator works.
I am not sure if the causa were the antivirus, but it was the only change.
Let's see future. It is working so I am afraid to turn OFF and have the same problem as before …
Best regards to all.
73 Manuel Fernando - CT1BXX
Hi,
Because communication between Swisslog and PstRotator (as well as many other applications such as WSJT-X) is done by TCP/UDP ports, it's highly advisable to add an exception to Swisslog and the other program to your antivirus to allow all incoming/outgoing connections. Most antivirus block Tcp/Udp connections and that's the reason you had troubles.
Best 73