16-09-2018, 11:09 AM
I can not set Yaesu FT2000 correctly with Swisslog. I have an SB-2000 interface.
I attach the screen: where am I wrong?
![[Image: Com%20Port%20Options.png]](http://www.polistenaweb.it/Com%20Port%20Options.png)
![[Image: Transceiver-Control-Interface.png]](http://www.polistenaweb.it/Transceiver-Control-Interface.png)
I attach the screen: where am I wrong?
16-09-2018, 12:24 PM
Hello,
Set 4800 bauds and 2 Stop bits instead of 1. Also uncheck the Dtr/Rts checkboxes.
I recommend to use OmniRig (free) or VSPE (Virtual Serial Port Emulator if you want to setup directly to a COM port) if you need to share CAT with other programs such as WSJT-X, MixW, etc. Otherwise you will get COM port conflicts.
Best 73
Set 4800 bauds and 2 Stop bits instead of 1. Also uncheck the Dtr/Rts checkboxes.
I recommend to use OmniRig (free) or VSPE (Virtual Serial Port Emulator if you want to setup directly to a COM port) if you need to share CAT with other programs such as WSJT-X, MixW, etc. Otherwise you will get COM port conflicts.
Best 73
16-09-2018, 03:39 PM
Changing this: DTR/SDR and RTS/CTS Force Off it works.
Thank you
Thank you