Frezing after solve End Time Problem - Printable Version +- Swisslog's Forum (https://www.swisslogforwindows.com/forum) +-- Forum: Swisslog version 5.x (https://www.swisslogforwindows.com/forum/forumdisplay.php?fid=3) +--- Forum: General discussion (https://www.swisslogforwindows.com/forum/forumdisplay.php?fid=4) +--- Thread: Frezing after solve End Time Problem (/showthread.php?tid=594) |
Frezing after solve End Time Problem - py1fr - 08-05-2019 After updating the swisslog.exe file because of the problem in the end time log, the software froze a few times, even when just being open but not being used. What should I do? Any tips? 73! RE: Frezing after solve End Time Problem - EA3GCV - 08-05-2019 Hello Fernando, Please download again the Beta (in the same link). I have made some corrections to avoid this. Best 73 RE: Frezing after solve End Time Problem - py1fr - 09-05-2019 Hi Jordi, I downloaded the new Beta, but the problem persists. After some time the software freezes. 73! RE: Frezing after solve End Time Problem - py1fr - 09-05-2019 Hi Jordi! The problem does not occur using WSJT-X, only with JTDX, both in UDP mode. 73! RE: Frezing after solve End Time Problem - EA3GCV - 16-05-2019 Hi Fernando, Please download a new beta in the same link. Now it should work ok. Best 73 RE: Frezing after solve End Time Problem - py1fr - 16-05-2019 Ok Jordi, many thanks. I will download the new beta. 73! |