IC7610 CAT not working - Printable Version +- Swisslog's Forum (https://www.swisslogforwindows.com/forum) +-- Forum: Swisslog version 5.x (https://www.swisslogforwindows.com/forum/forumdisplay.php?fid=3) +--- Forum: General discussion (https://www.swisslogforwindows.com/forum/forumdisplay.php?fid=4) +--- Thread: IC7610 CAT not working (/showthread.php?tid=701) |
IC7610 CAT not working - on6cc - 27-02-2020 Hi, I get the CAT connected but the frequency is not changing with it. When I click on the start button the frequency will change, but not while I'm tuning (dialing on the VFO). These are my setting: - Tranceiver ICOM - Start automaticly is ON - Show TX status on toolbar is ON - ICOM TX address is 98 (CIV) - Scan for TX Adress is ON - Time between.... 1/10 sec: 1 COMMUNICATION PORT - COM 4 - Baud rate: 19200 - Parity: None -Data bits: 8 - Stop bits: 2 The rest is not clicked upon - Trace is ON HAS ANYONE GOT HIS IC7610 CONNECTED TO SWISSLOG?? AND IS WORKING?? Connection in N1MM works fine... RE: IC7610 CAT not working - EA3GCV - 27-02-2020 Hello, Uncheck the "Scan TX Address" option because you are already setting the Hex address. This option is useful if you don't know the Hex address. ICOM uses 1 Stop bits not 2. Trace option is only to see the COM port communication for debugging purposes. I recommend to uncheck it. If you use WSJT-X, JTDX, FLDIGI or any other external digital modes program linked with Swisslog, I recommend to use OmniRig or VSPE to share CAT among all these applications. Please read this link: https://www.swisslogforwindows.com/english/Help/Features/HamScope%20Support.htm#CAT You will also find it in the Swislsog help: Digital Modes Interfaces > Setup > Important about transceiver control. Best 73 RE: IC7610 CAT not working - on6cc - 27-02-2020 Hi Jordi! Thanks for your quick reply! I tried the option you refered to but it didn't work. What did work for me is OMNIRIG. I installed this small program and it worked for me. I use the Microkeyer II, so I can use 2 com ports to communicate with Swisslog and JTDX at the same time. So for ICOM users is this the option I guess. Best 73 Marc RE: IC7610 CAT not working - EA3GCV - 28-02-2020 Hi Marc, Yes, OmniRig is one of the best options nowadays where sharing CAT is a must between several applications. You can achieve it to make it working /(I have a IC-756Pro3) with VSPE but OmniRig is easiest to set up. Best 73 |