missing FT2

[DL1IP]

Hi Jordi,

FYI, I've noticed these two things.

1. Export log to WSJT-X JTDX , Mode selection missing FT2
End 2.  Entry of QSOs      Membership Panel Rhein Ruhr DX Association

The problem always occurs on restart.

Otherwise, everything's great and thanks.
VY 73 DL1IP

[EA3GCV]

Hi,

OK point number one. It will be fixed. But you can add FT2 easily by editing the SWISSLV5.INI file, locate the WSJTEXport section and add FT2 in the Modelist key this way:

Modelist=FT2,FT4,FT8,ISCAT,JT4,JT65,JT9,MSK144,QRA64,T10,WSPR

But could you explain in detail what happens with RRDXA? You have not explained the issue.

73

[DL1IP]

... everytime I DE-CHECK the boxes it works fine, but they are automatically checked again after restart/re-boot.

[DL1IP]

Hi,

OK point number one. It will be fixed. But you can add FT2 easily by editing the SWISSLV5.INI file, locate the WSJTEXport section and add FT2 in the Modelist key this way:

Modelist=FT2,FT4,FT8,ISCAT,JT4,JT65,JT9,MSK144,QRA64,T10,WSPR

But could you explain in detail what happens with RRDXA? You have not explained the issue.

73

 editing the SWISSLV5.INI  Modelist=FT2 is fb ok.. 
Thanks vy 73 DL1IP

[EA3GCV]

Hi,

I have released a beta that fix this and adds all supoorted modes from WSJT-X/JTDX.

You have check the "Save desktop at exit" which is available in the main Options menu. Otherwise all changes are only applied to the current session only.

73

[DL1IP]

Hi Jordi,
Ok, fine.
thanks for your reply and info.
vy 73 Karl