Swisslog's Forum › Swisslog version 5.x › General discussion v
Rotor control

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Rotor control
17-09-2021, 12:37 PM,
#2
EA3GCV Offline
Super Moderator
******
 		Posts: 1.890
Threads: 167
Joined: May 2013
Reputation: 13
RE: Rotor control
Hi Tom,

You don't explain which rotor interface are using. If Swisslog is closed then you should not have any problem. Keep in mind that you can't share a COM port in 2 applications at once. So I guess your rotor COM port remains open somehow. Review carefully the COM port setup.

73
Jordi, EA3GCV
Current developer of Swisslog
Find
Reply


Messages In This Thread
Rotor control - by JW6VDA - 17-09-2021, 12:27 PM
RE: Rotor control - by EA3GCV - 17-09-2021, 12:37 PM
RE: Rotor control - by JW6VDA - 18-09-2021, 09:20 AM
RE: Rotor control - by JW6VDA - 18-09-2021, 02:24 PM
RE: Rotor control - by EA3GCV - 21-09-2021, 02:23 AM
RE: Rotor control - by JW6VDA - 21-09-2021, 08:05 AM
RE: Rotor control - by JW6VDA - 18-10-2021, 03:45 PM
RE: Rotor control - by EA3GCV - 19-10-2021, 12:29 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)