synchronizing LoTW not working

[EA3GCV]

Hi,

This happens because you have not configured properly TQSL & Swislsog. If you still have the old computer, open TQSL then go to File / Save certificates, station locations and configuration. In a single file you have EVERYTHING! no need to request new certificates. Then in your new computer simply RESTORE this file and you will have TQSL exactly as it was in the old computer. This is a MUST to be done to keep a backup copy of your certificates and configuration. If something goes wrong or you change the computer (or you want to install TQSL in a another computer) is as simple as installing TQSL and restore this file.

Now probably you have requested new certificates and you can't do this operation again. So now open TQSL then create your station locations again for every certificate. It's very important to know if certifcate are passwrod protected or not (check certificate propeties).

Now open Swisslog and go to Tools / LOTW synchronization > Configuration tab. In the Station / QTH left section you will need to assign again the TQSL Station locations to the corresponding My QTH (it's a drop dow list which reads the contents from TQSL). In the Password section make sure to set a password for every certificate (if any). Don't confuse the password certificate with the password used to LOG IN in your LOTW account.

Best 73