DX Messages window

[G3WPF]

Hi Reg,
Maybe the INIis corrupted somehow... Restore a copy of the SwisslV5.ini from your backups (if you have any). Or rename the ini to SwisslV5_old.ini and start Swisslog. Swisslog will create it from scratch,so you will have to setup everyrhing again. Try and see if now works.

Best 73

Hi Jordi.

I have tried both an old backup and a new INI but still the same.  Perhaps tomorrow I will try a re-install as I can't think of anything further to try.

### UPDATE:  Today I switched on Swisslog and the DX Messages window spots seem to be OK.  First spot logged at 1136 and at 1150 it is still there with 75+ spots listed after it.

Very strange!

73

Reg G3WPF