FT991A with Swisslog

[EA3GCV]

Hi Guy,

It's very weird... it should work if you have set in Swisslog the same COM port settings as you have defined in OmniRig. Make sure OmniRig is not running otherwise you will get an error message that COM port is already is use.

Check in the radio menu that you have set a fixed baud rate (DO NOT use AUTO). Use the highest baud rate as possible. I think this transceiver supports 38400. Remember that 2 as stop bits are only used for 4800 baud rate. For other baud rates you need to set 8 start bits and 1 stop bits.

If you still have issues contact me via whatsapp to arrange a remote session to check what happen.

73