Swisslog's Forum › Swisslog version 5.x › General discussion v
Flickering VFO's

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Flickering VFO's
24-02-2023, 10:15 PM, (This post was last modified: 24-02-2023, 10:18 PM by EA3GCV.)
#2
EA3GCV Offline
Super Moderator
******
 		Posts: 1.691
Threads: 147
Joined: May 2013
Reputation: 12
RE: Flickering VFO's
Hi Bent,

This happens because OmniRig is polling radio all time to read both VFO by sending the FA; and FB; commands. Close all programs using OmniRig (such as Swisslog) then make sure Omnirig.exe is not loaded into memory (go to Task manager). Close it in case you find it. Edit the TS-590.INI file located in the c:\Program Files (x86)\Afreet\OmniRig\Rigs\ folder with a text editor (mouse right click then select EDIT). Find the READ STATUS section at the end of the file then add ; at the beggining of this section (just like this):

[STATUS3]
;Command=(FB;)
;ReplyEnd=(;)
;Validate=(FB...........;)
;Value1=2|11|vfText|1|0|pmFreqB

Save the INI then open Swisslog. Now you should only see the selected VFO of your radio.

Best 73
Jordi, EA3GCV
Current developer of Swisslog
Find
Reply


Messages In This Thread
Flickering VFO's - by LA0GE - 24-02-2023, 04:30 PM
RE: Flickering VFO's - by EA3GCV - 24-02-2023, 10:15 PM
RE: Flickering VFO's - by LA0GE - 28-02-2023, 11:25 PM
RE: Flickering VFO's - by EA3GCV - 01-03-2023, 02:56 AM
RE: Flickering VFO's - by LA0GE - 01-03-2023, 12:19 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)