Swisslog's Forum › Swisslog version 5.x › General discussion v
LoTW and Special Callsigns

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
LoTW and Special Callsigns
03-06-2014, 08:42 AM, (This post was last modified: 03-06-2014, 08:43 AM by EA3GCV.)
#3
EA3GCV Offline
Super Moderator
******
 		Posts: 1.692
Threads: 147
Joined: May 2013
Reputation: 12
RE: LoTW and Special Callsigns
Hello Atila,

Obviously you had a bad callsign settings in your certificate which mades it didn't match your certificate callsigns with each of your My QTH callsigns.

However after having corrected the callsigns you have to perform a full sync of your logbook again.

In the LoTW function go to "Processing", press "Synchronise LotW" and in the QSO and QSL fields set a date of your first QSO or earlier so that you can perform a full sync of your whole logbook. Then press "Start Sync" and wait. Afterwards check again your confirmations percentatge.

Best 73
Jordi, EA3GCV
Current developer of Swisslog
Find
Reply


Messages In This Thread
LoTW and Special Callsigns - by TA1DX - 31-05-2014, 08:26 PM
RE: LoTW and Special Callsigns - by TA1DX - 31-05-2014, 10:20 PM
RE: LoTW and Special Callsigns - by EA3GCV - 03-06-2014, 08:42 AM
RE: LoTW and Special Callsigns - by TA1DX - 04-06-2014, 07:29 PM
RE: LoTW and Special Callsigns - by EA3GCV - 05-06-2014, 08:49 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)