WSJT-X UDP Settings Ok, but no RST reports

[py1fr]

Hello Fernando,

Are you using the latest version of JTDX 18.1.92? I use JTDX daily and I have never had any problem. Full QSO data stream is sent to Swisslog after clicking the Log QSO button (or if you have enabled automatic logging, just after JTDX receives the RR73 or RRR). Make sure you add an exception to Swisslog and JTDX in your antivirus and firewall to ensure it's not blocking the UDP communication. Use also latest Swisslov version 5.98b. There have been changes in the data stream sent by WSJT-X /JTDX. If you use old versions of these programs this could be the reason.

Best 73

Hello Jordi.

Many thanks for your help.

I will install the latest version of WSJT-X and JTDX, and inform you the results.

73!

Hello Jordi,

I upgraded the JTDX software and it only works well using TCP mode.
In UDP mode at the end of the QSO an error message appears.
I'm using TCP mode then, and everything is ok.

In WSJT-X at the end of the QSO, the RST send and receive are not transferred to the swisslog.

73!