Telnet Control Window error.

[G4UGB]

Hi Jordi,

I have a strange issue with my SwissLog.

It was working absolutely fine up until this afternoon - but now - when I come to access the Telnet Control Window and manually starting the spot downloads by selecting the single little lightning strike icon - I get an error window cycling forever - cannot close Swisslog - and have to use Task Manager to shut it down.

I have attached a screen grab of the error. I have rebooted the PC - reinstalled Swisslog - and it runs up 100% and works OK. But - as soon as I select the little single lightning strike icon - the error pops up immediately and keeps going until I shut down SwissLog using Task Manager.

I did a full dskchk on my C drive - no errors reported.

Any ideas what might be causing this ??

Regards,

Richard G4UGB