Swisslog's Forum › Swisslog version 5.x › General discussion v
Telnet Control Window error.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Telnet Control Window error.
10-09-2019, 09:23 PM,
#3
G4UGB Offline
Member
***
 		Posts: 72
Threads: 20
Joined: Feb 2015
Reputation: 0
RE: Telnet Control Window error.
Hello Jordi,

Thank you. But SwissLog is already exempted from the Firewall - I never changed any Firewall settings - this just happened this afternoon.

I did attach a small jpg screen shot of the error - a box keeps reappearing every couple of seconds and in it - it says 'Access Violation at address 00479C32 in module 'SwissIV5.exe' Read of address 00000180' and I cannot stop it happening unless I use Task Manager to shut down SwissLog.

I have not a clue why this just started to happen out of the blue today because - I have changed nothing at all.

Thanks and regards,

Richard G4UGB
Find
Reply


Messages In This Thread
Telnet Control Window error. - by G4UGB - 10-09-2019, 08:41 PM
RE: Telnet Control Window error. - by EA3GCV - 10-09-2019, 09:09 PM
RE: Telnet Control Window error. - by G4UGB - 10-09-2019, 09:23 PM
RE: Telnet Control Window error. - by EA3GCV - 12-09-2019, 12:57 AM
RE: Telnet Control Window error. - by G4UGB - 12-09-2019, 03:11 AM
RE: Telnet Control Window error. - by EA3GCV - 13-09-2019, 01:46 AM
RE: Telnet Control Window error. - by G4UGB - 13-09-2019, 10:40 AM
RE: Telnet Control Window error. - by G4UGB - 26-09-2019, 01:00 AM
RE: Telnet Control Window error. - by EA3GCV - 26-09-2019, 09:38 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)