IC7610 CAT not working

[on6cc]

Hi,

I get the CAT connected but the frequency is not changing with it. When I click on the start button the frequency will change, but not while I'm tuning (dialing on the VFO).

These are my setting:

- Tranceiver ICOM
- Start automaticly is ON
- Show TX status on toolbar is ON
- ICOM TX address is 98 (CIV)
- Scan for TX Adress is ON
- Time between.... 1/10 sec: 1

COMMUNICATION PORT

- COM 4
- Baud rate: 19200
- Parity: None
-Data bits: 8
- Stop bits: 2

The rest is not clicked upon

- Trace is ON

HAS ANYONE GOT HIS IC7610 CONNECTED TO SWISSLOG?? AND IS WORKING??

Connection in N1MM works fine...