Rotor hy-gain DCU-3

[HB9CVM]

From original manual:

Software Control
Follow the instructions for the software
package that you use to control the rotator
for setup and operation. For example in Ham
Radio Deluxe the Rotator control module
asks for the Controller Type and the COM
Port number. Other software vendors may
also include the ability to directly control the
DCU-3 from within a logging or rig control
program. Use the DCU-1 (or DCU-3 if in
the list) and look for the COM port that the
DCU-3 is plugged into. For RS-232 you
should have a list of COM 1-4 (or more)
depending on what is installed in the
computer and you would choose the one that
the DCU-3 is plugged into. For USB you
should have the COM 1-4 list and then a
higher number COM list of the devices
plugged into the computer that act as virtual
com ports. Choose the one that the DCU-3 is
connected to. If you unplug the DCU-3 the
USB com port should no longer be
available. If you have chosen the correct
com port then when instructed by the
software the rotator should respond to the
commands. If not then try one of the other
com ports.
 

I use usb - com port 6!

73 de HB9CVM