Swisslog's Forum › Swisslog version 5.x › General discussion v
Rotor hy-gain DCU-3

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Rotor hy-gain DCU-3
29-03-2020, 04:44 PM,
#4
HB9CVM Offline
Junior Member
**
 		Posts: 5
Threads: 2
Joined: Mar 2020
Reputation: 0
RE: Rotor hy-gain DCU-3
And the commands

COMMAND SET
There are 2 commands the DCU-3 is
looking for that are sent as ASCII
characters.
Command: Result:
AP1***; Sets Target Bearing in DCU-3 (***is a three digit number between 000 and 359)
AM1; Starts Rotation to Target Bearing


73 de HB9CVM
thanks for answer!
Find
Reply


Messages In This Thread
Rotor hy-gain DCU-3 - by HB9CVM - 29-03-2020, 01:01 PM
RE: Rotor hy-gain DCU-3 - by EA3GCV - 29-03-2020, 02:58 PM
RE: Rotor hy-gain DCU-3 - by HB9CVM - 29-03-2020, 04:40 PM
RE: Rotor hy-gain DCU-3 - by HB9CVM - 29-03-2020, 04:44 PM
RE: Rotor hy-gain DCU-3 - by EA3GCV - 29-03-2020, 06:43 PM
RE: Rotor hy-gain DCU-3 - by HB9CVM - 29-03-2020, 07:43 PM
RE: Rotor hy-gain DCU-3 - by EA3GCV - 29-03-2020, 10:26 PM
RE: Rotor hy-gain DCU-3 - by EA3GCV - 30-03-2020, 11:54 AM
RE: Rotor hy-gain DCU-3 - by EA3GCV - 30-03-2020, 03:32 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)