Swisslog's Forum › Swisslog version 5.x › General discussion v
Rotor hy-gain DCU-3

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Rotor hy-gain DCU-3
29-03-2020, 10:26 PM, (This post was last modified: 29-03-2020, 10:31 PM by EA3GCV.)
#7
EA3GCV Offline
Super Moderator
******
 		Posts: 1.689
Threads: 147
Joined: May 2013
Reputation: 12
RE: Rotor hy-gain DCU-3
Hi Albin,

Some rotors are very limited and this rotor only has 2 commands: set bearing to a specific bearing and start this action, nothing else. Please let me know what's the difference between HRD and Swisslog. I will appreciate if you have any additional command documentation but apparently DCU-3 it should work with DCU-1. Maybe it has more commands. Please send me the DCU-3 manual to support@swisslogforwindows.com

Best 73



Jordi, EA3GCV
Jordi, EA3GCV
Current developer of Swisslog
Find
Reply


Messages In This Thread
Rotor hy-gain DCU-3 - by HB9CVM - 29-03-2020, 01:01 PM
RE: Rotor hy-gain DCU-3 - by EA3GCV - 29-03-2020, 02:58 PM
RE: Rotor hy-gain DCU-3 - by HB9CVM - 29-03-2020, 04:40 PM
RE: Rotor hy-gain DCU-3 - by HB9CVM - 29-03-2020, 04:44 PM
RE: Rotor hy-gain DCU-3 - by EA3GCV - 29-03-2020, 06:43 PM
RE: Rotor hy-gain DCU-3 - by HB9CVM - 29-03-2020, 07:43 PM
RE: Rotor hy-gain DCU-3 - by EA3GCV - 29-03-2020, 10:26 PM
RE: Rotor hy-gain DCU-3 - by EA3GCV - 30-03-2020, 11:54 AM
RE: Rotor hy-gain DCU-3 - by EA3GCV - 30-03-2020, 03:32 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)