Rotor hy-gain DCU-3

[EA3GCV]

Hi Albin,

I have achieved the DCU-3 manual and should work well with the DCU-1 rotor option of Swisslog because it uses the same commands. Only set bearing and start turning to this nearing. Nothimg else. According to the manual:

"There are no provisions at this time to send current bearing information back to the computer."

So seems this control unit only is valid to set bearings from Swisslog and other software but you won't get any bearing info from this unit, so it's very limited comoared to other control units.

Please explain in detail what you mean about not" starting" because requesting turning the rotor from Swisslog should work. Make sure you have selected 4800 bauds, 8 start bits, 1 stop bit and parity None in the COM settings.

Best 73