IC-7300 Swisslog/JTDX - Omnirig help

[dk4rh]

Hi, I am also struggeling.
Have an FT-991A on Rig1 with Omnirig 1.19. Alsways connected with WSPR-X (has also to be OmniRig-V1.19).
Since two weeks a IC-7300. Had configure for Rig2 with Omnirig V1.19. But Swisslog is not working, hanging etc.
After this installed Omnirig V2.1 in addition. FT-991A on Rig1 with OmniRigV1.19, IC-7300 on Rig2 with OmniRigV2.1.
Swisslog is only working, if WSPR-X is not active. Than I can handle the IC-7300 with Swisslog.
If WSPR-X is startet, OmniRigV1.19 is always active. When I start than Swisslog and activate the Setup for OmniRig (by activated V2) the Popup of OmniRigV1.19 comes up.
Quite strage. Think there is still a compatibility issue with OmniRig....

Question for Swisslog (V5.99g):
- Could it be, that for Omnirig V1.19 is an issue that those is not working correctly (by inactivated V2-Flag).
- Currently I have deactivated OmniRig for the IC-7300. Swisslog is going directly on the COM-Port. Here the polling seems not to work. After Startup of Swisslog, or change of Tranceiver-Settings the current frequency/mod is red out. But not continiously. Have changed the parameter of "Zeit zwischen TX-Abfragen in 1/10 Sekunden". But also no change. ==> Could it be, that polling is not active?

73 dk4rh Roland