IC-7300 Swisslog/JTDX - Omnirig help

[EA3GCV]

Hello Roland,

Omnirig v2 is only supported by Swisslog. The OmniRig option in WSJT-X is only for OmniRig v1. You don't need to use Omnirig v2 if you want to use Swisslog and WSJT at once. Do the following:

- Uninstall Omnirig v2 or set to NONE all Rigs in Omnirig v2 to make sure Omnirig v2 is not using any COM port.
- Configure your IC-7300 in OmniRig v1.19 as Rig2 but set the DTR and RTS lines LOW. Start bits 8 and Stop bits 1.
- Make sure Swisslog, WSJT-X and OmniRig are executed with the same priviliges. That is: all of them WITHOUT administrators rights or ALL of them WITH administrator rights. The key is that all programs must be at the same level of privileges otherwise it won't work.

Add exceptions to OmniRig, WSJT-X and Swisslog in your antivirus and firewall. This will ensure they are not blocking the communication between these programs.

Summing up: only use Omnirig v.1.19 and setup both RIGS on it. In Swisslog you can switch from one rig to another easily by clicking the rig number in the transceveir control toolbar. In WSJT-X you have to go to Setup / Radio then select Omnirig Rig 1 or Omnirig Rig2 when needed. but this setup is the best because you can use both transceivers at once without any conflict.

If you have any issues contact me via whatsapp to +34 656409020 to arrange a remote session via Teamviewer but it must work if you follow the above instructions.

Best 73