Swisslog's Forum › Swisslog version 5.x › Error reports v
Elecraft KX3 CAT's strange behaviour

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Elecraft KX3 CAT's strange behaviour
15-05-2020, 08:01 PM,
#6
RN3ANT Offline
Junior Member
**
 		Posts: 4
Threads: 1
Joined: Aug 2018
Reputation: 0
RE: Elecraft KX3 CAT's strange behaviour
Thank you very much, Jordi!

Lower COM-port's rate really works! The only active VFO freq and current mode are indicated properly if COM-port rate is 9600 baud.
Moreover, special KY-codes used by Elecraft for CW-keying of K3, KX3 & KX2 transceivers from some loggers, f.e. N1MM+, now acts absolutely correct! LOL.

Yours,
73! Vit, RN3ANT
Website Find
Reply


Messages In This Thread
Elecraft KX3 CAT's strange behaviour - by RN3ANT - 08-05-2020, 01:28 AM
RE: Elecraft KX3 CAT's strange behaviour - by RN3ANT - 15-05-2020, 08:01 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)