Swisslog's Forum › Swisslog version 5.x › Error reports v
Omnirig V2 & version 5.100a

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Omnirig V2 & version 5.100a
25-07-2020, 11:42 AM,
#2
EA3GCV Offline
Super Moderator
******
 		Posts: 1.689
Threads: 147
Joined: May 2013
Reputation: 12
RE: Omnirig V2 & version 5.100a
Hello Henny,

Yes you right! I have not found the reason because I haven't chsnged anything on the OmnIRIg or transceiver code! However I have found out a very easy work around: install OmniRig v1 from VE3NEA. Then it will work again! A real X File! Both versions of OmniRig can be installed. Moreover, if you plan to use WSJT-X, JTDX or MixW, you will be able to use OmniRig v1 (OmniRig v2 is only supported in Swisslog). So take this into account because you will be able to share CAT control using Swisslog and these applications at once with no problems.

Best 73
Jordi, EA3GCV
Current developer of Swisslog
Find
Reply


Messages In This Thread
Omnirig V2 & version 5.100a - by PA3HK - 23-07-2020, 09:27 PM
RE: Omnirig V2 & version 5.100a - by EA3GCV - 25-07-2020, 11:42 AM
RE: Omnirig V2 & version 5.100a - by PA3HK - 26-07-2020, 11:33 AM
RE: Omnirig V2 & version 5.100a - by EA3GCV - 27-07-2020, 02:32 PM
RE: Omnirig V2 & version 5.100a - by S52RA - 27-07-2020, 05:19 PM
RE: Omnirig V2 & version 5.100a - by PA3HK - 28-07-2020, 01:18 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)