Swisslog's Forum › Swisslog version 5.x › General discussion v
New Qso Operator name / qth?

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
New Qso Operator name / qth?
16-08-2020, 04:20 PM, (This post was last modified: 16-08-2020, 04:33 PM by KE4BCN.)
#1
KE4BCN Offline
Member
***
 		Posts: 58
Threads: 22
Joined: Jun 2020
Reputation: 0
New Qso Operator name / qth?
I have been reading through the documentation and I have not found out why some qso's have operator name and qth and others don't. For each new QSO the Operator field is initialized with the name of the callsign owner (station owner). That means that the value stored in C_OP_Name is copied into L_Operator. So when there is information in the Name/QTH field that should copied to the Operator name qth?


Attached Files Thumbnail(s)
       
Find
Reply


Messages In This Thread
New Qso Operator name / qth? - by KE4BCN - 16-08-2020, 04:20 PM
RE: New Qso Operator name / qth? - by EA3GCV - 17-08-2020, 09:02 AM
RE: New Qso Operator name / qth? - by KE4BCN - 17-08-2020, 02:59 PM
RE: New Qso Operator name / qth? - by KE4BCN - 18-08-2020, 03:00 PM
RE: New Qso Operator name / qth? - by EA3GCV - 18-08-2020, 04:11 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)