Rotor control
Hello. I am qsl manager with my club, and because of that I have installed Swisslog and made user profiles ("My QTH") for all users. It works without a hitch on our main station.
We have also installed N1MM+ for contests, and because most of our club members are relatively new hams, and because it is a relatively uncomplicated user interface, most of our members prefer using N1MM+ also for general logging.
I have set up the N1MM+ rotor control software, and it works like it's supposed to do.
BUT, and here comes my question: After setting up the rotator control in Swisslog, and using it without any problems, it seems like this is blocking the N1MM+ Rotor control. It seems like something is hanging after I close Swisslog (even after restarting the computer), because I am unable to operate the rotor from N1MM+ Rotor control, even if the settings have not changed, and everything looks normal.
Any ideas what can cause this and how it can be avoided? Personally I would very much like to use the integrated rotor control functions in Swisslog, but because of the other users preferring N1MM+, I cannot do that.
Best regards Tom
Happy Swisslog user since 1989.
JW6VDA permanently may 1983 - august 1989 and august 2001 - august 2014.
LA6VDA 1989-2001.
Now OH6VDA since september 2014.
|