Swisslog's Forum › Swisslog version 5.x › General discussion v
Problem with Statistic and QTH name

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Problem with Statistic and QTH name
25-05-2018, 12:31 PM,
#2
EA3GCV Offline
Super Moderator
******
 		Posts: 1.691
Threads: 147
Joined: May 2013
Reputation: 12
RE: Problem with Statistic and QTH name
Hello,

it's obvious that something goes wrong there. First of all: are you using the latest Swisslog versión 5.97k? If not, please install it! Check it again and test. I corrected a problem in 5.97j that if you are querying DXCC to CLub Log and there is no response (poor internet connection, etc), the Swisslog country table is used. Prior to 5.97j this didn't happen and a blank DXCC was assigned. That's the reason you always have to use the latest version. I guess you are not using latest Swisslog version.

Best 73
Jordi, EA3GCV
Current developer of Swisslog
Find
Reply


Messages In This Thread
Problem with Statistic and QTH name - by on6cc - 24-05-2018, 10:24 PM
RE: Problem with Statistic and QTH name - by EA3GCV - 25-05-2018, 12:31 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)