Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Propagation Mode Reset
17-05-2019, 01:57 PM,
#1
Propagation Mode Reset
Hello,
I am not sure if there is shortcut for it or not..
Couldnt figure out how to reset propagation mode status reset

I mean.. assume i made a qso with Satellite and set prop mode according to this..
Then after qso, if I switch to other band or jump across the spectrum via cluster list, I can not select an empty propagation mode unless I make a qso and save.

Is there a "reset to default" mode for logging screen??
Reply
18-05-2019, 01:17 PM, (This post was last modified: 18-05-2019, 01:18 PM by EA3GCV.)
#2
RE: Propagation Mode Reset
Hello,

It's very simple: if you work satellites, select SAT from the Prop Mode field. If you change to other modes, in the next QSO delete manually the content of the Prop Mode (which will be SAT) and that's all. All QSOs from that time will be saved without the Prop Mode. It's not reseted automatically because this is user choice. Swisslog keeps the setting of the previous saved QSO to avoid selecting again the Prop mode if you are working QSO in this mode. When you change band or not working Satellites, delete the contents of the prop mode and the following QSOs will be saved without it.

Best 73
Jordi, EA3GCV
Current developer of Swisslog
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)