Setting up Swisslog and WSJT-X for communication with IC7300

[EI4KF]

After my last post, I discovered that when the radio starts a tx period in WSJT-X, the rx filter changes from the default FIL1 (BW 3.6K) to FIL2 (with 500Hz BW). Also, the mode reported by Swisslog is RTTY, not USB-D or USB. This is not a wanted effect, and I wonder what causes it. I will now start changing the parameters of the radio, one at the time to see the effect.  CI-V USB Port = Link to remote causes WSJT-X to crash. 
Changing CI-V Baudrate from Auto to  19200 had no apparent effect.

I changed the CI-V -> Remote Tranceive Address to 00h, and it changed nothing.

I changed the Mode on WSJT-X to USB. The filter still changes from FIL1 to FIL2 on tx.

Any hints would be much appreciated.
 I´ve sent you a message on WhatsApp. I don't think this can be resolved with teamViewer, though.

73 de Tom OH6VDA

Check the Mode setting on the radio tab in wsjtx. If it not set to 'None' try that setting and that should stop the software sending commands to Omnirig. If it is already set to None, let us know.

Erik.