Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
05-11-2019, 08:47 PM,
Has anyone idea how to make a report (.rpt) for DXCC award
which shows
every needed DXCC slots (callsigns), who confirmed by qsl card but NOT confirmed by LoTw
this report separates for SSB, CW, DIGI

73 Chris SV2DGH
05-11-2019, 11:59 PM, (This post was last modified: 06-11-2019, 01:46 PM by EA3GCV.)
Hi Chris,

There is a report created that may help you. Follow these steps:

- Go to View / Logbook view (selection)
- Select the query "Confirmed QSO by QSL or LoTW" located in the Examples folder
- Open the autofilter of the QSL Rec field and select 1 (confirmed)
- Open the autofilter of the LOTW Rec field and select 0 (not confirmed)
- Drag the DXCC header to the upper gray part. This will group the selected QSO by DXCC.
- Now you will have a DXCC grouped listing (showing the number of QSOs for every DXCC).
- Now you can open the autofilter in the Mode field to select a specific mode or a couple or modes if you use the Custom filter (equal to xxx or equal to xxx). The same applies for specific bands.
- Open every node to see the QSOs confirmed by QSL but not by LoTW for every entity.
- You can set your filters off in the lower part (click on the X button located at the beginning of the filter expression)

Here you can copy all/or certain QSOs to a specific QSO-Group, etc. You can play with lots of parameters according to your needs.

Best 73
Jordi, EA3GCV
Current developer of Swisslog
06-11-2019, 09:50 AM,
Jordi Thank You very much
73 Chris

Forum Jump:

Users browsing this thread: 1 Guest(s)