Hi,
I get the CAT connected but the frequency is not changing with it. When I click on the start button the frequency will change, but not while I'm tuning (dialing on the VFO).
These are my setting:
- Tranceiver ICOM
- Start automaticly is ON
- Show TX status on toolbar is ON
- ICOM TX address is 98 (CIV)
- Scan for TX Adress is ON
- Time between.... 1/10 sec: 1
COMMUNICATION PORT
- COM 4
- Baud rate: 19200
- Parity: None
-Data bits: 8
- Stop bits: 2
The rest is not clicked upon
- Trace is ON
HAS ANYONE GOT HIS IC7610 CONNECTED TO SWISSLOG?? AND IS WORKING??
Connection in N1MM works fine...