Swisslog's Forum › Swisslog version 5.x › General discussion v
Rotor hy-gain DCU-3

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Rotor hy-gain DCU-3
29-03-2020, 06:43 PM,
#5
EA3GCV Offline
Super Moderator
******
 		Posts: 1.689
Threads: 147
Joined: May 2013
Reputation: 12
RE: Rotor hy-gain DCU-3
Hi Albin,

According to this, commands are the same as DCU-1! If your problem is that rotor is not started, did you check the "Start automatically" check box in Options / Rotor interface???

Best 73
Jordi, EA3GCV
Current developer of Swisslog
Find
Reply


Messages In This Thread
Rotor hy-gain DCU-3 - by HB9CVM - 29-03-2020, 01:01 PM
RE: Rotor hy-gain DCU-3 - by EA3GCV - 29-03-2020, 02:58 PM
RE: Rotor hy-gain DCU-3 - by HB9CVM - 29-03-2020, 04:40 PM
RE: Rotor hy-gain DCU-3 - by HB9CVM - 29-03-2020, 04:44 PM
RE: Rotor hy-gain DCU-3 - by EA3GCV - 29-03-2020, 06:43 PM
RE: Rotor hy-gain DCU-3 - by HB9CVM - 29-03-2020, 07:43 PM
RE: Rotor hy-gain DCU-3 - by EA3GCV - 29-03-2020, 10:26 PM
RE: Rotor hy-gain DCU-3 - by EA3GCV - 30-03-2020, 11:54 AM
RE: Rotor hy-gain DCU-3 - by EA3GCV - 30-03-2020, 03:32 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)