Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Verbindung MixW
17-06-2020, 10:27 AM,
#1
Verbindung MixW
Hello Jordi!
I have a problem with version 599g after I reinstall it
No connection to MixW 3.1.1 the red dot remains and there is none
Connection to MixWin what am I doing wrong.
Thanks for your help
LG Erich from Austria
Reply
17-06-2020, 10:38 AM,
#2
RE: Verbindung MixW
Hello Jordi!
The message is
Access violation at address 0062A7CB in the module
Swiss IV5.exe Read from address 00000008
Reply
17-06-2020, 05:15 PM,
#3
RE: Verbindung MixW
Hello Erich,

Because MixW is installed in the Program Files folder which is protected by Windows, you have to run both programs (Swisslog and MixW) with administrator rights. Do the following:

- Mouse right click in the EXE file of every program (SwisslV5.exe and Mix3_1.exe), select Properties > Compatibility tab and check the "Run as administrator" option.

Now the link between both programs will work perfectly.

Best 73
Jordi, EA3GCV
Current developer of Swisslog
Reply
19-06-2020, 09:22 AM,
#4
RE: Verbindung MixW
Hello Jordi!
Unfortunately without success I tried to reinstall MixW on C: \
swisslog but unfortunately no connection between the two programs.
It used to work perfectly, so I should get one again
Install older Swisslog version ???
LG Erich
Reply
19-06-2020, 07:48 PM,
#5
RE: Verbindung MixW
Hello Erich,

This is not a problem of the Swisslog version. I use latest version of Swisslog and MixW 3.2 but I have to run Swisslog and MixW as administrator otherwsie I get the same Violation error message. It's very important to add exceptions to Swisslog and MixW in your antivirus and firewall. Most tend to block the DDE communication between Swisslog and MixW. I have always used MixW (I have W10 64 bits) with no problems in any Swisslog version but:

- I run both programs with administrator rights
- Added exceptions in antivirus/firewall for BOTH programs as well. Also in any antimalware or similar program you use. These kinds of programs are a nightmare for many amateur radio programs (such Swisslog) and it's a must to add exceptions to avoid they block its regular functioning.

If you still in trouble I can review your computer remotely via Teamviewer. Contact me via whatsapp (my phone nunber is in the contact section of the website). For it should work.

Best 73
Jordi, EA3GCV
Current developer of Swisslog
Reply
21-06-2020, 10:08 AM,
#6
RE: Verbindung MixW
Hello Jordi!
Thanks for your help everything is ok Swisslog and
MixW works perfectly, so everything is OK
Thanks again a nice Sunday
LG Erich
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)