Questions on interfacing to IC7610

[EA3GCV]

Hello Chuck,

First of all thank you for using Swisslog! I'm sure you won't regret it.

Regarding your question, OmniRig sets RTTY to all DATA modes, this is normal. But when a QSO is passed from WSJT/JTDX into Swisslog the right QSO mode is set. If you want to see SSB instead of RTTY you would have to setup your ICOM directly in Swisslog but because real COM ports can't be shared, you will need to use VSPE or similar program to use a virtual COM port which can be shared. Summing up: you don't have to worry about that because the real mode of operation is saved in the QSO.

Swisslog only reads VFO A and it's not reading VFO B so it can't be displayed. If you need a better CAT control you can use an external program supported by Swisslog (and also by WSJT-X and JTDX) such as HRD, DxLab Commader or TRX Manager where you can get full control over the radio.

Best 73