Hi Chris,
The set up for WSJT-X / JTDX and JT Alert is explained in the Digital Modes Interfaces > WSJT-X / JTDx Operation in the Swisslog help:
https://www.swisslogforwindows.com/engli...t.htm#WSJT
There is a very highlighted note for JT Alert users. When using JT Alert, you have to do the following:
- In JTALERT go to
Settings > Manage Settings > Applications > WSJT-X then check the
Rebroadcast WSJT-X UDP Packets (received only) option with the default option through port
2334 (this is ok in your configuration, according your attached screenshots). Uncheck the
Enable transmission of last QSO in
Last QSO API through port 2333 unless you really need it for other application.
- However, I guess you have not set this port in Swisslog. So go to
Options | Digital Modes-Interface | WSJT-X / JTDX | UDP Settings and set the same settings defined in JT Alert (127.0.0.1 and port 2334).
Now WSJT-X and JT Alert will communicate each other through port 2337 (the default port) and JT Alert will rebroadcast UDP packets to Swisslog through port 2334, so 3 programs will be working together without any conflicts.
Best 73