Com ports with Micro Keyer II and Swisslog

[JW6VDA]

Hi Tom,

Have you followed the schematic explained on page 29 of the Expert 1FK-FA operating manual? This schematic must be used to share the CAT connection of the Expert when controlling CAT from your PC. The TX TTL line from the Expert must be disconnected. Have you tried with another software if you have the same behaviour?

Best 73

Another solution is to simply create a new Port  (say COM 5) in uRouter software and assign it to 2nd CAT. It will get the radio frequency same as your COM 4. Let Swisslog interface with it which leaves the original CAT to the SPE amplifier intact and working as before.

Erik.

Thanks, That worked